Sprint Car Wing Slider Cylinder Clamp. Black.Sprint Car Wing Slider Cylinder Clamp clamps to the top rail in place of a welded tab. Facilitates infinite adjustments, or can be used in the event of a tab being broken off. Precision machined so the through bolt also acts as the pinch bolt. Anodized black for a great looking finish. Clamp ID is 1. 5", so will fit every Sprint Car chassis on the market. ID (fits tube): 1 1 2" Cylinder Hole: 1 4" Cylinder Hole Gap (Width for Rod End on Cylinder): 0.

5 pounds over fiberglass

Winters heat-treated 10-10 Spline internal coupler for sprint car rear ends

Length: 1 1/4"

30 lb bar is 2 1/2" Wide x 2 1/2" Tall x 12" Long

Chassis Geometry: Same design as the most popular chassis on the market today

Bolt head is lightened for even more weight savings

Heel riser has a non-skid top surface

DMI Tetris right front hub

or degradation

Material: High pressure grease

This billet aluminum throttle arm is designed for maximum strength and weight savings

Pump Side Bend: 45 Degree