Hydraulic expansion chuck HSK 100 - 10 - 90Application: For mounting straight shank tools acc. DIN 1835 form A+B+E and DIN 6535 form HA+HB+HE (larger than dia. 20 mm only with reduction sleeve). Note: l1 = max. clamping depth l2 = max. length adjustment range Delivery: Without wrench All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile

With wrench

For horizontal clamping of flat workpieces

Ergonomic Handle of Design

- Repeating accuracy 0

From DCONWS = 25 on two clamping screws

For mounting straight-shank tools in collet chucks ISO 15488 (ex

Carbide tipped scriber with clamp

Taper angle tolerance < AT 3 according to DIN 2080

There is no need to set the zero position each time the caliper is used as the origin setting is retained even when the caliper is switched off

Standard (over 25mm range)

With ball bearing clamping nut

Without toolholders and inserts