Shrink chuck 4,5° HSK 63 - 18 - 95Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Metallic sealed for mounting straight-shank tools with coolant-through in collet chucks ISO 15488 (ex

Mainly for external machining

For the manufacturing of special tools

From DCONWS = 25 on two clamping screws

Warranty card

For the transfer of a defined torque

5 with h4-tolerance and Ø 6 - Ø 32 with h6-tolerance

The insert is clicked into our grid system with

the control lamp lights up = identification of the reference point

Spannkraft voreinstellbar durch Rillenmarkierung

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance

For collets KPS-system